BHP+60 hp (15%)
Standard
390 hp
Tuned
450 hp
Torque+400 Nm (22%)
Standard
1850 Nm
Tuned
2250 Nm
Suitability
Good (7/10)Gains Profile
Torque-focusedHeadroom
MediumIveco EuroTech 390hp ECU Remapping
Considering an ECU remap for your Iveco EuroTech 390hp? A Stage 1 remap can take this All diesel engine from 390 BHP to 450 BHP and from 1850 Nm to 2250 Nm of torque (turbocharged). This engine scores 7/10 for remap suitability. Get a free personalised quote from a trusted remap professional and find out exactly what your Iveco EuroTech can achieve.
How this engine compares
- 7thof 15 Iveco EuroTech engines by power gain
- 86%of the 9,842 engines we hold gain data for see a smaller power increase
- 99%of engines with torque data see a smaller torque increase
Comparisons are calculated from our own recorded Stage 1 figures.
Assessment
The Iveco EuroTech 390hp is a turbocharged diesel engine producing 390 BHP and 1850 Nm from the factory. With a typical Stage 1 remap, output increases to approximately 450 BHP and 2250 Nm — a gain of around 60 BHP (15%) and 400 Nm (22%).
This engine has moderate remap suitability, with gains weighted towards torque — you will notice the difference most strongly in mid-range pulling power and in-gear acceleration. The tuning headroom is classified as moderate, based on the percentage gain available from the factory output.
Considerations: High tuned torque: check transmission torque capacity and service history.
Fuel economy note: possible improvement with conservative driving.
All figures shown are typical estimates based on aggregated Stage 1 data for this engine variant. Actual results depend on vehicle condition, mileage, and the chosen tuning method. We recommend discussing your specific vehicle with a qualified remap professional.
Considerations
!High tuned torque: check transmission torque capacity and service history.
Other EuroTech All Engines
| Engine | BHP | Gain |
|---|